Kenwood tk 981 manual
![kenwood tk 981 manual kenwood tk 981 manual](https://unicomradio.com/wp-content/uploads/2021/03/UC01KM.jpg)
Move to the place where you want the copied frequencies to be placed and press Ctrl+V. Place the cursor on the Group, then press Ctrl+C. Move back to the frequency you want to move.
![kenwood tk 981 manual kenwood tk 981 manual](https://www.picclickimg.com/00/s/NDgwWDY0MA==/z/g8sAAOSw8MJbv6Lz/$/Kenwood-Tk-7302Hv-1-Tk7302H-136-174Mhz-50W-2-Zone-16-_1.jpg)
Select the system you want to move to and press F2, then select conventional. If you have created or set up a bank of frequencies, you can now copy (Ctrl+C) and paste (Ctrl+V) any frequency to any system. In the group edit window, the actual operating frequency will be shown in ‘frequency’ window at top. To delete, enter Delete with the cursor on FCC number. Never try to edit this number, unless you want to delete the line. If all went well, there will be a seven digit number where the two digit FCC number was for each system. Run KPG-49D and open the file created in step 3 using the File menu at top of screen.If all was done correctly, the frequencies will be converted to 902-927 MHz. At this point, do not select E (edit) but just press enter.
KENWOOD TK 981 MANUAL FULL
Enter the full name of the file you saved in the previous step including the. When finished, save the file by: File> Save as>, then choose Data File when asked what type of file to save. Repeat step 1 with next system number and continue to add frequencies as desired. Close this window with ‘Close’ button to return to system information.The maximum is 10 characters, including spaces. Whatever is entered in the ‘Group Name’ column is what will be displayed on the radio for the frequency chosen. Data for all other columns can be entered now or edited later, as needed. In the FCC Channel column, enter the two digit FCC number for the channel you want from the programming number sheet (at bottom). Next press the ‘system edit’ button and the system edit window will open.This can be a repeater location or operating frequency and can be edited later if need be. Highlight the ‘not used’ entry and choose ‘conventional’ from the drop-down menu. You will see a system information window open with lines numbered from 1 to 32, all marked “not used” in the mode column. dat files will be saved in, within KPG-49D application.
![kenwood tk 981 manual kenwood tk 981 manual](https://i.ebayimg.com/images/g/ne4AAOSwAb1cn6uc/s-l400.jpg)
KENWOOD TK 981 MANUAL INSTALL
I recommend you install the KW900EZP.exe in the same folder (DATA) as the.